When operating the Systec IT3, it's crucial to adhere to safety guidelines to protect both the user and the device:
The IT3 is W&M approved as a non-automatic weighing instrument (NAWI), complying with major international standards:
Press the [->0<-] (Zero) key. This establishes a true zero point, provided the scale is stable and within the allowed zero-tracking range. systec it3 user manual
The serves as the authoritative, comprehensive technical blueprint for configuring, operating, and maintaining the highly resilient SysTec IT3 Universal Industrial Weighing Terminal . Designed for extreme operational security in brutal manufacturing layouts, this Weights & Measures (W&M) approved terminal processes complex weight metrics with immense speed.
Weight exceeds capacity. Remove the load immediately. When operating the Systec IT3, it's crucial to
| Code | Meaning | User Action | |------|---------|--------------| | | Door not sealed | Check gasket; re-close door firmly | | E-12 | Temperature rise too slow | Check heater; verify water supply | | E-34 | Vacuum pump failure | Clean pump filter; call service | | E-41 | Air detector fault | Run automatic vent test (menu 7-2-1) |
For system integrators, the IT3 Blackbox is a compact, display-less version of the weighing electronics. It is designed for installation inside a control cabinet, providing the same weighing capabilities without the operator interface. Its configuration is typically performed via a PC and the IT Configurator software, with an optional remote display for weight readout. Remove the load immediately
Visually inspect the scale base for debris buildup, which can cause mechanical binding and lead to weighing inaccuracies.
Dynamic PC/PLC remote operation using serial or Ethernet commands. Configuration & Interface Options