Soundtracs Topaz 12 4 Manual Jun 2026

The console uses an , meaning each strip contains both a main signal path and a monitor signal path.

The four group faders allow you to control submixes. For example, you can route all drum channels to Groups 1 and 2, allowing you to turn the entire drum kit up or down with just two faders. These groups can then be routed directly to the main L-R mix via assignment switches above the group faders. Master L/R Fader

This article serves as a comprehensive guide for the Soundtracs Topaz 12-4, covering its features, signal flow, and operational techniques. 1. Introduction to the Soundtracs Topaz 12-4 Soundtracs Topaz 12 4 Manual

: Routes the playback from a stereo master recorder directly to the monitoring system for quick A/B comparisons. Setup and Gain Staging Guide

Push down the routing switch located next to the Channel 1 fader. The console uses an , meaning each strip

Controls the return signal's volume and position in the stereo monitor mix.

Roughly 680 mm depth, with varied width based on channel count (e.g., 24/32 channels). 6. Maintaining the Soundtracs Topaz These groups can then be routed directly to

💡 If you own a Topaz today, check the rear panel; you can achieve a very tidy setup because all the jacks (except the XLR mic inputs) are tucked away in the back.