Used to select and store individual firing profiles.
The Programat P100 features customizable programs tailored for various ceramic systems, including vintage IPS Classic, IPS Empress, and modern universal porcelain lines. How to Program a Firing Cycle
Proper placement prevents premature electronic failures and ensures uniform firing results. ivoclar programat p100 manual english
Plug the main furnace power cord into a grounded wall outlet and flip the main power switch to the "On" position. 2. Keypad Layout and Interface Navigation
Check the vacuum hose connection, inspect the table O-ring, and verify the vacuum pump fuse. Heating muffle failure or open circuit. Used to select and store individual firing profiles
The English manual reveals a heavy emphasis on the user experience. Unlike modern touchscreens, the P100 utilizes a tactile, membrane-protected keypad and a clear vacuum-fluorescent display. This design was intentional: it allowed technicians to operate the furnace with gloved, sometimes dusty hands without damaging the electronics. The menu logic—organized by program numbers—allowed for a "set it and forget it" workflow, which was revolutionary for high-volume labs. The Physics of the Vacuum
Press the key, input the heating rate (e.g., 60°C/min), and press ENTER . Plug the main furnace power cord into a
| Error Code | Description | Manual Reference | Solution | |------------|-------------|------------------|----------| | E-01 | Thermocouple open circuit | Sec. 8.2 | Check connection; replace TC | | E-07 | Vacuum not reaching setpoint | Sec. 8.5 | Inspect pump, hoses, or door seal | | E-12 | Heating rate too slow | Sec. 8.7 | Check heating elements for wear | | --- | Furnace does not start | Sec. 5.1 | Verify power switch and fuse |
- Source: stock-dent.ru
If the wire melts early or late, use the temperature offset utility in the system menu to adjust the furnace calibration up or down. General Maintenance Checklist
The speed at which the temperature rises, measured in °C per minute.