Icom Ui7 Am Fm Unit Install — Fix

: A precision screwdriver (usually #1 or #2) matching your radio’s chassis screws.

Test the FM mode by checking for reception on a local 10-meter (29.600 MHz) or 6-meter repeater frequency (if applicable).

Before opening the radio chassis, you must isolate the equipment from all power sources to prevent short circuits or electrical shock. : Turn off the radio using the main power button.

: Carefully lift or slide the cover away from the main chassis.

: Plug the antenna, power cable, and microphone back into the radio. Power On : Turn on the transceiver.

: The radio's CPU may not recognize the hardware. Double-check if a configuration jumper needs to be clipped, or try resetting the radio's CPU (usually done by holding a specific key combination, like [FUNCTION] + [POWER] ).

Once you've completed the installation and configuration, it's time to test the AM/FM unit:

Whether your UI-7 unit is a board or a pulled/used unit?

Connect the speaker wires to the Icom UI-7 unit. The speaker wires typically connect to the unit's speaker terminals, which are labeled for easy identification.

Do not use the ID-5100’s remote control head cable as a substitute for the OPC-2359. The pinouts are different. You will either get no audio or blow a capacitor.

Remove the DC power cable from the back of the transceiver.

Allow the radio to sit for a few minutes to allow internal capacitors to discharge. 3. Installation Step-by-Step

: Remove the DC power cable from the back of the radio. Do not rely solely on the front power switch.

Remove the top cover, being mindful of any internal wires connecting to a speaker, if applicable. Step 2: Locate the Installation Spot