|
|
Most Annoy Tools boards use a CH340 USB-to-serial chip. You need to install the driver for your computer to recognize the board.
12V–24V DC (Recommended: 24V 5A for spindle motors). Firmware: GRBL v1.1.
Plug the 3-pin laser cable into the dedicated PWM laser port. Do not connect both a spindle and a laser simultaneously. Step 3: Install Limit Switches (Optional but Recommended) annoy tools cnc board manual pdf
Marked for advanced users who need to reflash the GRBL firmware using an AVR programmer. Laser/Spindle Jumper:
Connect the 4-pin connectors of the X, Y, and Z stepper motors to the corresponding sockets labeled X-STEP, Y-STEP, and Z-STEP on the board. 2. Spindle or Laser Most Annoy Tools boards use a CH340 USB-to-serial chip
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Offline Controller Port: An 8-pin or 5-pin header for manual jogging without a PC. Limit Switch Headers: For homing and preventing crashes. USB Port: Standard Type-B or Mini-USB for PC connection. Basic Wiring and Installation Firmware: GRBL v1
Annoy Tools users often share tips on community platforms to fix common issues.
a specific error code you're seeing.
Generally supports DC 7-36V (spindles up to 48V/500W).